View PCS3P7100A_4501744.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

January 2007 rev 0.3 Custom Clock Generator for Display Systems
PCS3P7100A
Features
* * * * * * *
wide choice of pixel frequencies. PCS3P7100A of EMI of reduces electromagnetic interference (EMI) at the clock source, allowing system wide reduction all clock dependent signals. PCS3P7100A shielding allows significant system cost savings by reducing the number of circuit board layers ferrite beads, that are traditionally required to pass EMI regulations. The Supply Voltage of the Device is 3.3V/2.5V. It has two Spread Selection Pins, SS1% and SS2%. Refer to the Spread Deviation Selection Table for details.The Device is available in 6 Pin TSOT-26 Package,in Commercial and Industrial Temperature grade.
Custom Clock Generator for Display Systems 30-100MHz Wide Operating Frequency Range covering most of the pixel frequencies Generates a low EMI 1x Output 4 Spread Deviation selection options Supply voltage : 3.3V / 2.5V 6 Pin TSOT-26 package Commercial and Industrial Temperature range
Product Description
PCS3P7100A is a versatile spread spectrum modulator designed specifically for a wide range of clock frequencies. The device addresses the need of a low EMI clock generator for use in display systems covering
Applications
PCS3P7100A is targeted for use in Display Systems
Block Diagram
VDD
SS1%
SS2%
CLKIN
PLL
ModOUT
VSS
PulseCore Semiconductor Corporation 1715 S. Bascom Ave Suite 200, Campbell, CA 95008 * Tel: 408-879-9077 * Fax: 408-879-9018 www.pulsecoresemi.com
Notice: The information in this document is subject to change without notice.
January 2007 rev 0.3
Pin Configuration (6L TSOT- 26 Package)
PCS3P7100A
CLKIN VSS ModOUT
1 2 3
6
VDD SS2% SS1%
PCS3P7100A
5 4
Pin Description Pin#
1 2 3 4 5 6
Pin Name
CLKIN VSS ModOUT SS1% SS2% VDD
Type
I I O I I P Ground to entire chip Modulated Frequency Output
Description
External Reference Input frequency.
Spread Deviation Selection Pin -1. Refer to "Spread Deviation Selection Table" for details. Has an Internal pull-up resistor. Spread Deviation Selection Pin -2. Refer to "Spread Deviation Selection Table" for details. Has an Internal pull-up resistor. Power to entire chip
Spread Deviation Selection Table SS2% Pin
L L H H
SS1% Pin
L H L H
Spread Deviation @ 55MHz
1.50% 1.25% 0.75% 1.00%
Custom Clock Generator for Display Systems
Notice: The information in this document is subject to change without notice.
2 of 7
January 2007 rev 0.3
Absolute Maximum Ratings Symbol
VDD, VIN TSTG TA Ts TJ TDV Storage temperature Operating temperature Max. Soldering Temperature (10 sec) Junction Temperature Static Discharge Voltage (As per JEDEC STD22- A114-B)
PCS3P7100A
Parameter
Voltage on any pin with respect to Ground
Rating
-0.5 to +4.6 -65 to +125 -40 to 85 260 150 2
Unit
V C C C C KV
Note: These are stress ratings only and are not implied for functional use. Exposure to absolute maximum ratings for prolonged periods of time may affect device reliability.
DC Electrical Characteristics for 2.5V Supply Symbol
VIL VIH IIL IIH VOL VOH IDD ICC VDD tON ZOUT Input low voltage Input high voltage Input low current Input high current Output low voltage (VDD = 2.5V, IOL = 8 mA) Output high voltage (VDD = 2.5V, IOH = 8 mA) Static supply current* Dynamic supply current (2.5V and no load) Operating voltage Power-up time (first locked cycle after power-up) Output Impedance
Parameter
Min
VSS - 0.3 2.0 1.8 2.375 -
Typ
10 2.5 40
Max
0.8 VDD + 0.3 -35 35 0.6 2.5 2.625 5 -
Unit
V V A A V V mA mA V mS
* CLKIN pin is pulled low
AC Electrical Characteristics for 2.5V Supply Symbol
CLKIN ModOUT fd tLH* tHL* tJC tD Input frequency Output frequency Frequency Deviation (SS2%=SS1%=1) Input Frequency = 30MHz Input Frequency = 100MHz
Parameter
Min
30 30 40
Typ
1.55 0.35 2.2 1.2 250 50
Max
100 100 60
Unit
MHz MHz % nS nS pS %
Output rise time (measured from 0.7V to 1.7V) Output fall time (measured from 1.7V to 0.7V) Jitter (Cycle to cycle) Output duty cycle
* tLH and tHL are measured into a capacitive load of 15pF
Custom Clock Generator for Display Systems
Notice: The information in this document is subject to change without notice.
3 of 7
January 2007 rev 0.3
DC Electrical Characteristics for 3.3V Supply Symbol
VIL VIH IIL IIH VOL VOH IDD ICC VDD tON ZOUT Input low voltage Input high voltage Input low current Input high current Output low voltage (VDD = 3.3V, IOL = 8 mA) Output high voltage (VDD = 3.3V, IOH = 8 mA) Static supply current* Dynamic supply current (3.3V and no load) Operating voltage Power-up time (first locked cycle after power-up) Output Impedance
PCS3P7100A
Parameter
Min
VSS - 0.3 2.0 2.5 3.0 -
Typ
12 3.3 40
Max
0.8 VDD + 0.3 -35 35 0.4 3 3.6 5 -
Unit
V V A A V V mA mA V mS
* CLKIN pin is pulled low
AC Electrical Characteristics for 3.3V Supply Symbol
CLKIN ModOUT fd tLH* tHL * tJC tD Input frequency Output frequency Frequency Deviation (SS2%=SS1%=1) Input Frequency = 30MHz Input Frequency = 100MHz
Parameter
Min
30 30 45
Typ
1.55 0.35 1.5 1.1 225 50
Max
100 100 55
Unit
MHz MHz % nS nS pS %
Output rise time (measured from 0.8 to 2.0V) Output fall time (measured at 2.0V to 0.8V) Jitter (Cycle to cycle) Output duty cycle
*tLH and tHL are measured into a capacitive load of 15pF
Custom Clock Generator for Display Systems
Notice: The information in this document is subject to change without notice.
4 of 7
January 2007 rev 0.3
Package Information 6L TSOT26
PCS3P7100A
Dimensions Symbol
A A1 A2 b b1 c D E E1 e e1 L L1 L2 R R1 y
Inches Min Max
0.0295 0.00 0.0275 0.0157 0.0118 0.0031 0.1023 0.0590 0.035 0.0039 0.0314 0.0197 0.0157 0.0078 0.1181 0.0069
Millimeters Min Max
0.75 0.00 0.70 0.40 0.30 0.08 2.60 1.50 0.90 0.10 0.80 0.50 0.40 0.20 2.90 REF 3.00 1.70 0.95 BSC 1.90 BSC 0.30 0.60 0.60 REF 0.25 BSC 0.10 0.10 0 .... ..... 0.25 8 0.10
0.1141
0.0374 0.0748 0.0118 0.0236 0.0236 REF 0.0098 BSC 0.0039 0.0039 0 .... ..... 0.0098 8 0.0039
Custom Clock Generator for Display Systems
Notice: The information in this document is subject to change without notice.
5 of 7
January 2007 rev 0.3
Ordering Codes Part Number
PCS3P7100AG-06JT PCS3P7100AG-06JR PCS3I7100AG-06JT PCS3I7100AG-06JR
PCS3P7100A
Marking
AA2LL AA2LL AA4LL AA4LL
Package Type
6-Pin TSOT-26, TUBE, Green 6-Pin TSOT-26, TAPE & REEL, Green 6-Pin TSOT-26, TUBE, Green 6-Pin TSOT-26, TAPE & REEL, Green
Temperature
Commercial Commercial Industrial Industrial
Device Ordering Information
PCS3P7100AG-06JR
R = Tape & Reel, T = Tube or Tray O = TSOT23 S = SOIC T = TSSOP A = SSOP V = TVSOP B = BGA Q = QFN DEVICE PIN COUNT F = LEAD FREE AND RoHS COMPLIANT PART G = GREEN PACKAGE, LEAD FREE, and RoHS PART NUMBER X= Automotive I= Industrial P or n/c = Commercial (-40C to +125C) (-40C to +85C) (0C to +70C) 1 = Reserved 2 = Non PLL based 3 = EMI Reduction 4 = DDR support products 5 = STD Zero Delay Buffer 6 = Power Management 7 = Power Management 8 = Power Management 9 = Hi Performance 0 = Reserved U = MSOP E = TQFP L = LQFP U = MSOP P = PDIP D = QSOP X = SC-70 J= TSOT26
PulseCore Semiconductor Mixed Signal Product
Licensed under U.S Patent Nos 5,488,627 and 5,631,921
Custom Clock Generator for Display Systems
Notice: The information in this document is subject to change without notice.
6 of 7
January 2007 rev 0.3
PCS3P7100A
PulseCore Semiconductor Corporation 1715 S. Bascom Ave Suite 200 Campbell, CA 95008 Tel: 408-879-9077 Fax: 408-879-9018 www.pulsecoresemi.com
Copyright (c) PulseCore Semiconductor All Rights Reserved Preliminary Information Part Number: PCS3P7100A Document Version: v 0.3
Note: This product utilizes US Patent # 6,646,463 Impedance Emulator Patent issued to PulseCore Semiconductor, dated 11-11-2003
(c) Copyright 2006 PulseCore Semiconductor Corporation. All rights reserved. Our logo and name are trademarks or registered trademarks of PulseCore Semiconductor. All other brand and product names may be the trademarks of their respective companies. PulseCore reserves the right to make changes to this document and its products at any time without notice. PulseCore assumes no responsibility for any errors that may appear in this document. The data contained herein represents PulseCore's best data and/or estimates at the time of issuance. PulseCore reserves the right to change or correct this data at any time, without notice. If the product described herein is under development, significant changes to these specifications are possible. The information in this product data sheet is intended to be general descriptive information for potential customers and users, and is not intended to operate as, or provide, any guarantee or warrantee to any user or customer. PulseCore does not assume any responsibility or liability arising out of the application or use of any product described herein, and disclaims any express or implied warranties related to the sale and/or use of PulseCore products including liability or warranties related to fitness for a particular purpose, merchantability, or infringement of any intellectual property rights, except as express agreed to in PulseCore's Terms and Conditions of Sale (which are available from PulseCore). All sales of PulseCore products are made exclusively according to PulseCore's Terms and Conditions of Sale. The purchase of products from PulseCore does not convey a license under any patent rights, copyrights; mask works rights, trademarks, or any other intellectual property rights of PulseCore or third parties. PulseCore does not authorize its products for use as critical components in life-supporting systems where a malfunction or failure may reasonably be expected to result in significant injury to the user, and the inclusion of PulseCore products in such life-supporting systems implies that the manufacturer assumes all risk of such use and agrees to indemnify PulseCore against all claims arising from such use.
Custom Clock Generator for Display Systems
Notice: The information in this document is subject to change without notice.
7 of 7

▲Up To Search▲

Price & Availability of PCS3P7100A

	To Download PCS3P7100A Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .